Compressed Air Quality Testing Services | ISO 8573 Compliance

Compressed air quality testing is the process of sampling and analyzing compressed air at the point of use to measure levels of contamination including solid particles, moisture, oil and hydrocarbons, and viable microorganisms. Because compressed air is drawn from the surrounding environment and passes through compressors, piping, filters, and dryers before reaching its end use, it can carry a range of contaminants that pose risks to product quality, equipment performance, and regulatory compliance. Testing provides documented, quantified results that confirm whether your system meets the purity standards required by your industry.

ISO 8573 testing measures the three primary categories of contamination in compressed air: solid particulates, water and moisture, and oil including hydrocarbons. Each contaminant category is assessed against a numbered purity class, ranging from Class 0 (the strictest) to Class 9 (the most permissive), so facilities can verify their air quality against the specific classification their application requires. Some versions of the standard also address microbiological contamination, which is particularly relevant for pharmaceutical, food, and healthcare environments.

If your facility uses compressed air that comes into direct or indirect contact with drug products, medical devices, or food and beverage products, then yes, demonstrating compressed air quality is an expectation of FDA cGMP regulations. While the FDA does not prescribe a specific testing frequency, compressed air is considered a critical utility under quality system regulations, and the expectation is that it is validated, monitored, and documented as part of your overall quality program. ISO 8573 is the most widely accepted standard used to satisfy that requirement.

Clean Dry Air, or CDA, is a grade of compressed air that has been processed to remove virtually all moisture, particles, and hydrocarbons, typically to very stringent purity levels. It is most commonly used in semiconductor fabrication, electronics manufacturing, and aerospace applications where even trace contamination can damage sensitive components or compromise precision processes. CDA testing verifies that your air supply meets the ultra-clean specifications these industries require, often going beyond standard ISO 8573 classes to application-specific limits.

The on-site sampling portion of a compressed air test typically takes a few hours depending on the number of sample points, the tests being performed, and the size and complexity of your compressed air system. Particle count and dew point results can often be read immediately on-site, while microbial and hydrocarbon samples are sent to a laboratory for analysis. A full written report covering all test parameters is typically delivered within a few days of the site visit.

If your compressed air does not meet the required purity class, Class 1 Air will identify which contaminant or contaminants are out of specification and advise on the likely source of the problem, whether that is a failing filter, a compromised dryer, a contaminated distribution line, or another system issue. From there, corrective action can be taken and the affected sample points retested to confirm the system has been brought back into compliance. Catching a failure through routine testing is far preferable to discovering it through a product recall, a regulatory finding, or a contamination incident on the production floor.

Testing frequency depends on your industry, the regulatory framework your facility operates under, and how critical compressed air is to your process. For most regulated industries, annual testing is the baseline expectation. Pharmaceutical and medical device manufacturers typically test as part of a formal validation cycle, with requalification required any time a significant change is made to the compressed air system, such as a new compressor, filter replacement, or changes to distribution piping. Food and beverage facilities operating under SQF or HACCP programs are generally expected to test at least annually, with some certification bodies requiring more frequent monitoring at direct product contact points. Beyond scheduled testing, compressed air should also be tested following any contamination event, after corrective maintenance, or when product quality issues arise that could be attributed to air quality. Class 1 Air can work with your quality team to establish a testing schedule that meets your regulatory obligations and gives you year-round confidence in your compressed air system.